Click the drop down menu Scripts and select Script 1 (alternatively select Start Code in order to use this color scheme every time you slice). To enter a color representation in Repetier-Host of the mixed filament, for each of the extrudes below enter a name, then click the color rectangle, click Define Custom Colors > and enter the following Red, Green and Blue values:.Set a checkmark in the box Printer has a Mixing Extruder (one nozzle for all colors).In Config -> Printer Settings select the Extruder pane.Mixing extruder (one nozzle for all colors).3D-printer setup with Repetier-firmware v0.92 (or later) as specified above.A PC running Repetier-Host V1.6 or later (some earlier versions may work but these are not tested).If you have a board not mentioned here, please refer to the documentation of that board in order to obtain the necessary pin assignments. (pin numbers shown are the digital pins corresponding to a Ramps board with a Stepper Expander X1 connected as described on Adding more extruders) #define E2_PINS ORIG_E2_STEP_PIN,ORIG_E2_DIR_PIN,ORIG_E2_ENABLE_PIN, In Pins.h (scroll down into the “RAMPS pin assignment” section or the board matching your setup) make sure the following lines are present, if not add them: RUMBA boards already feature 6 stepper motor outputs so the below changes does not apply to that board. Since Ramps has only two on-board extruders drivers you physically need to attach a third extruder driver externally eg. Download the complete firmware at the end of the configurator.Optional: make appropriate changes to fit your specific printer.Then upload it to the configurator mentioned above.Go to File:DiamondRepetierConfiguration.h and save the file as configuration.h.In order to create a working setup it is possible to download a fresh copy of Repetier-Firmware from the v092 configurator
0 Comments
Leave a Reply. |